firstly power the blue overide wire if the solenoid clicks then it confirms the red light & operation is still functional.
Is there power at the power outlets from the acc battery? are these outlets fused??
are the plugs themselves still operational??
sometimes it the most simplest things that...
I run both Makits & Hitachi.
I like the Hitachi drill more but the makita gets used more as the batteries are interchangable with all my other makita gear I use daily.
Both have proven to cop a hiding wouldnt part with either.
But with the price of a Hitachi ill always give the apprentice the...
They use the same spring in both 4 & 6 cyl rigs??!? hmmm
Suspension is crud from start anyway just upgrade the lot springs & shocks with something deacent. Thicker bore is not always better.
I installed a HID set from fleabay. The light output was insane I never got flashed till I drove to QLD 12 months after the install I reliased they were reversed wired to the D40 so My low beam was the HID high beam on its circuit. Changed the terminals around in the H4 plug n play and was...
I removed the muffler & replaced it with a piece of pipe. Stock system is 2 1/4" from memory The converter kept the noise levels the same as with the muffler and opened it up a bit not bad for $50
You should have no worries using any set of shocks.
The UCA will only increase the distance between it and the top hat.
Have fun installing them too ;)
12mm is 12mm having IFS you need all the height you can get your hands on.
Try 235/85/R16 there tall yet thin. Just like my missus hahaha tall maybe...
If you can afford it a set of diff gears will bring the drive train to stock strains.
But still keep an eye on the bearings.