Think you could be right there. Needs to be enabled. Another $200 for the dealer LOLSo i got right up close with a torch and i can see the pcb and leds inside. So its certainly real. I think i need to contact nissan. I dont want to take off the roof lining. Perhaps the enable it in the body control module. Who knows
Ive been a panelbeater for 22 years and seen this before. There will only be one output for a centre brake light. If you have a roll bar it will be for that. If you remove the roll bar it will be a matter of routing the centre brake output to the cab led. Its quite common. Ill check it out this week and update the method for anyone who has removed there roll bar.Think you could be right there. Needs to be enabled. Another $200 for the dealer LOL
LED's are installed with the thought they will outlast the life of the vehicle.
Ive been a panelbeater for 22 years and seen this before. There will only be one output for a centre brake light. If you have a roll bar it will be for that. If you remove the roll bar it will be a matter of routing the centre brake output to the cab led. Its quite common. Ill check it out this week and update the method for anyone who has removed there roll bar.
What you said is exactly what will happen. An apprentice will rip and tear and youll be left with a couple of faint rattles or scratches in the trim. Ive also removed my sport bar because it serves no purpose other then block easy access to the rear of the tray. I believe Australia is the only country they added a sports bar. I havnt connected the cabin brake light as yet but it wont be more the a 30 min job. Will probably get to it tomorrow and will post once complete. CheersThanks. I traced the wiring for the roll bar and it runs back the the passenger side tail light. Simply splices into that loom. There are no other cables anywhere near by to connect this to, the roof led will be part of the interior loom.
Nissan have told me to bring it in, they say this is the first they have seen someone removing the roll bar (really???). They commented its illegal to run with it not working. They say it will probably be free. I just dont want 3 apprentices pulling my interior to pieces resulting in rattles and broken clips throughout...
No worries mate.Legendary!! Ty so much!
Enter your email address to join: