Recent content by jeffb7449

had injector pump checked it checked out okay. Still don't no where fuel came from will have to reassemble and check all connections etc and keep an eye on it.

I have been thinking about removing egr valve permanently for ease to injector lines etc. Has anyone done this?

well I checked the spill/return line no problem so I removed injector pump (fun job) and it is with diesel Australia getting new front seal and recalibrated. hopefully this will fix problem. When driven lightly it does not seem to leak much but when driven hard ie loaded it fills sump fairly...

I spoke to diesel Australia today and he says to check spill/return line as well he says it is unlikely to be the pump. I will have to investigate on the weekend.

i have not found any information on any special procedures etc for pump removel etc does any one have experience with this?

Has anyone had to replace input shaft seal on their injector pump?. Mine appears to be leaking diesel into sump according to a diesel fitter I spoke to. The sump level raised about 1/2 inch within 500klms.

well I got navara going again it needed a new computer and gearbox/diffs and transfer oils changed as they were full of water

I have blown out the ecu , connectors and fuse boxes with compressed air. The accelerator pedal was making a noise so I blew it out as well. The weather was really warm and sunny so things dried fairly quick. Had issue with mongoose immobilizer as well which I removed. Picked up another ecu...

Hi guys I got my nav stuck in a creek and water came in up to arm rest on drivers side. I have dried out every thing as much as possible but it will not start. The engine is okay (no water) but the ecu had some moisture in it. Nissan ran diagnostics but could not talk to computer. They say new...

well the instructions that came with it did not say anything about it and there is no wire to solder to.

Hi all I have a steinbaur chip in my 03 str zd30 navara which does not seam to work. I have taken it back for repair but still no difference. The wiring diagram supplied is for patrol. There is no throttle sensor wire just plug and play. Is there supposed to be a throttle sensor wire? and what...

That is interesting about the egr blanking plate. My 04 str had it done before I bought it but I find it very thirsty and lacking pulling power (33's don't help) I fitted a steinbuer chip which made little difference. I have 3" zorst no muffler I downsized the tailpipe to 21/2" which gave me...

i will have to try the air in fuel test on weekend, and the butterfly swirl mod was done before i bought vehicle. Thanks for the ideas

My zd30 was sluggish and noisy from when i bought it i ran some diesel power through it and it made a noticeable difference in noise and a slight performance increase. The power has slowly improved over time. I am running 33" tyres which suck power but the problem is this, i have great initial...

cheers mate it is greatly appreciated.