Plazmaman Hot Side Intake Pipe not fitting

[Skebtor]

Hey guys, I recently bought a Plazmaman hot side kit (Navara ST-X/Pathfinder 550 V6 Hot Side Piping Kit - Plazmaman) for my Stx 550 and am having extreme difficulty with fitting the longer pipe on. It seems likely that the pipe isn't wide enough to slip on but I'm not sure so I was just wondering if anyone else was having the same problem if they've installed that kit as well, Thanks.

 

[viclord]

I did install a hot pipe in my ST D40 without an issue. See the photo in this post: 2012 stx550 Limp mode

 

[Skebtor]

I did install a hot pipe in my ST D40 without an issue. See the photo in this post: 2012 stx550 Limp mode

Yea nah I got it just had to take some extra stuff out, was a VERY tight seal but thanks.

 

[Aidan 550]

I did install a hot pipe in my ST D40 without an issue. See the photo in this post: 2012 stx550 Limp mode

I am doing the same job right now, did they supply the clip for the bottom of the hard pipe? Cant seem to release the factory one to use it... Thanks mate

 

[Aidan 550]

I am doing the same job right now, did they supply the clip for the bottom of the hard pipe? Cant seem to release the factory one to use it... Thanks mate

All good, I got it sorted!

 

[viclord]

All good, I got it sorted!

just FYI, they did provide a new clip for the bottom.