Search results

Scooba, how difficult was it to replace the turbo. Are there any tips you can provide? Cheers

Thanks guys, still unsure what to do. I might try & wrap the cool side first with some sort of reflective tape (to deflect heat from the hot side & general heat within engine bay). I guess it would be nice to know how well the air is being cooled before & after the intercooler. Whilst the...

Just wondering if it is recommended to wrap the hotside of my newly installed ASE Front Mount intercooler pipes. After driving the cold side feels quite hot close to the engine & am wondering if I will prevent most of this by wrapping the hotside to lower engine bay temps. The hotside &...

Thanks Bryce.

Thanks Tony, but I already have a Steinbauer chip. So I take it there is nothing I should do to adjust for the mods (without going down the Chipit road)? I forgot to mention I have also installed the 2.75 Beau exhaust. Cheers

Iam wondering if somebody can provide advice. I have recently done the EGR Butterfly mod, fitted snorkel & fitted intercooler. Should I go get the navara dyno'd? I am very happy with the mods but now wondering if I need to tune? Thankyou

No worries, got it off. Was not heavy at all. I had to separate the bar from the mounts first due to the mount design. Cheers

Can somebody give me some idea what the bullbar weighs? I intend removing it & am wondering how much help I will need to remove/lift from the mounts? Thankyou

Dave, I am about to fit the same intercooler as yours (ASE Front mount). You mentioned the tyre was rubbing against the pipe when turning. Should I modify the pipe some how? Cheers

I am happy to sell the 90mm Sutton holesaw I puchased from sparra04. It was a snug fit but worked a treat. PM me if interested.

Thought I would jump in & help those wishing to connect the bogaard turbo timer to the handbrake. I found the hadbrake wire (light brown) running from the centre console to under the passenger seat. I located it just behind the front seat mount. Just take off the plastic floor plate &...

I have the following mods: staunbeur chip, turbo boost gauge, catch can and are about to have the beaudesert exhaust fitted next week. I am also planning to do the egr/butterfly mod as suggested in this forum soon. However, I am putting off the intercooler mod (ASE Intercooler) till later due...

Mansfield, postcode 4122. Cheers

oops, the beudesert exhaust is actually $1135 + $300 for fitting.

I live in Brisbane (southside). The exhaust is $1250 + $300 for fitting. Comes with the 1/4"BSP Pyro mount. Sounds expensive but went on the good reviews from this forum?

Thankyou, might do the same before I attempt the EGR mod. Handy to have some spares anyway. Cheers

Thanks Josh. I should be right as I am going to Beudesert Exhausts for the dump pipe & exhaust & am going to give the EGR mod a go myself thanks to the great instructions on this website (fingers crossed all goes well). Cheers

Does anybody out there know the D22 vacuum hose size (inside diameter) & type (rubber or silicone) connecting to the solenoids? Thankyou

Vacuum Hose Size I was wondering, before I undertake this mod, what size the vacuum hose is? I might get some just in case I break an existing one. Thankyou

I would like to take my d22 to someone to do the EGR/Butterfy mod, dump-pipe & exhaust upgrade. I am not mechanically skilled. I live in South Brisbane. Any recommended mechanics to do the work? Thankyou