Recent content by trentd22

Cheers old tony I think I might remove it for services anyway its only a 10 min job

Sorry for being impatient but I want to do this tomorrow and would rather only have to make one haha

I went to pertek for some stuff once and got talking to the bloke and he was showing me some flexible piping he said 4wd buy them all the time for their snorkel kits because its flexible and an easy install. .

A bloke gave me some stainless steel the other day but its like 3mm which obviously isnt going to effect it but will be noticeable difference. Should I get some thinner stuff?

???

So am I right in thinking that all I have to do is make a blanking plate and put in in place of the gasket where I am pointing in the picture?

I have a yd25 engine and that is the zd30? Is there a difference?

I know there is a thread somewhere that shows you where to blank etc etc but I have been searching and cant find it. Can someone please link it and what is the thinnest stainless steel I should use? Hoping to make on up this weekend

Good stuff mate looks well built!

m.ebay.com.au/itm/300968229198?nav=SEARCH&sbk=1 Them switches cheap as but do the job! And they are just mounted inside the lift up door frame where the seal is (I cut a bit of seal out for them

I just got the switches off ebay. And the led I bought from the shop as a 5m roll which van be cut and re wired at any point. I have about 3m left over so I might go mad and led everything! Lol and the 12 volt I took from the existing 12v I had hooked up the the canopy light that was terrible...

I had a little toy around with my canopy on the weekend and install some courtesy switches on my lift up doors rigged up to some led strip lights. Just and idea to throw out for the felliw navers as I love it! And it cost about 3 bucks for two switches off ebay + the cost of led strips and...

I think they told me there is 8? But that makes sense because mine has been the front drivers side both times. .. then again I had to wait over three weeks and then call them again myself before they 'had the parts'. Hopefully this time will be faster in time for the long weekend!!

Oh well ill just get them to fix it.. again

Hey all. When I first got my nav within about One month and no real 4x4 work I noticed a noise on some corrigations and the local nissan replaced all the body mounts under warranty but now about 6 months later the noise is back? Is this a common fault with the navs?? I thought if they came out...