Recent content by Nanojuice1

Yeah i have read that people rate them as a good Tyre i cant understand why mine are so noisy and slippery though.

Hey guys have a set of these on my d40 and I cant believe how noisy they are after a couple of thousand k's my mates tell me that they are noisier than mud tires they have had on their rigs once i get over 50 km/ph all i can hear is tyre drone and to top it off they are very slippery, went out...

Rang around today couldn't source one through an auto wrecker but nissan had one sitting in Brisbane said he will give it to me for $240 just hope it arrives before next Tuesday so I can still go away, the guy at nissan said if I order it before 2pm there is a good chance I will see it Monday...

yeah that's what i am after, i was just going to see if i can source one through an auto wrecker need it before Christmas.

Yeah on P97 labeled heater core pipes i need the plastic box with the air bleed tube sticking out that connects to the heater hose but looks like it isn't a separate part and i will have to get the entire pipe, will get on the blower tomorrow and see if any wreckers have one. Thanks

Hey guys standing on the passenger side the heater hose that's closest to the drivers side connects into a plastic piece that joins onto a pipe running along the firewall also where the hose connects to the pipe there is a piece that sticks up about 30mm with a hose clamp on it (im assuming...

All good turning the ignition off seemed to of reset it, massive power difference throws me back into my seat now very happy customer.

Hey guys just received my new dominator mk1 by chip it, following the instructions on how to change the tunes (on board) it says on the last step that i need to turn the ignition off and the chip will be reset and the new tune will be set, but then it also says that i need to unplug the "fuse at...

Got my notice aswell booked in for Friday not sure how it affects me though as I have an ARB rear step and tow bar, will have to wait and see.

do you know if the probe that comes with the auto meter ultra light gauge is long enough to reach the gas flow?

Hey guys, Just a quick question regarding probe placement for a 07 d40 stx, is it alright to completely take out the egr pipe and make a backing plate for the manifold side with a tapped hole in it and place the probe there? By putting the sensor there will I get accurate readings or will I...