Hi had a problem like that . If the compressor clutch is not activating there is also a thermal fuse on the compressor and its in the plug on the compressor
I found it by measuring to see if 12volts was on the wire to the comp. clutch right down on the compressor. I just put a new plug on. This...
Remove the 2 small hoses at the top plastic over flow tank they go to the egr cooler pump that wont self prime. Pour coolant down them with a small funnel and that will fix it. You may have to do it twice .The 2457 is egr code for cooler flow. Make sure you have bled the hoses going to the...
I had the similar problem clutch not kicking in. In my case the fuse in fuse box was not blown.However I found they had another fuse in the plug connecting to the compressor which is mounted on the compressor itself and it was open circuit. It was a thermal fuse . I cut the plug and socket off...
I had to replace my pulley last year. You definitely need a rattle gun to remove the pulley safely and tool 33 point spline>Make sure you get the right pulley because they look the same but a slightly different offset and diameter. Nissan part number 23151-5X21A.
I have a 550 Nav and from WA and find that people sit on 92 to 95 on the freeway trying to be safe just under the speed limit 100. To be doing 100kms/h speedo reads 107.Have checked it on google maps, Garman sat nav and also plugged in my scan tool which must read straight off the computer and...
I' have put one of these modules on the air flow sensor 4 years and 60,000 kms ago never had a problem. They trick the ecu into thinking the air temp is cold not the the coolant. They don't recommend EGR blanking plate. The resistor is 4.7k. in the patch cable. At least you get get the right...
I have had this fault before after i drained and replaced the coolant. It has has an egr cooler pump that must have to be primed. Fixed by pulling the cooler hoses off at the top near the coolant reservoir and pouring coolant down, had to use a small funnel and do it a couple of times.
There are 2 different types. The one in video is Thai vin starts MNT. Mine was Spain VSK and broke it 1st time getting it out to change puddle lamp.
Got a new one on ebay for $40 nissan want $200. If you have a spain one like mine make sure to push it out close to centre of glass not near the...
I went to costco they had michelin ones for my 550 at $12 each that's the whole arm and they are very good.Also seen them on ebay for $35.00 a pair including
delivery. There very easy to fit. Just unclip the whole arm and clip the new ones in,just make sure you hear them click in job done.
The fan resistor is near the air intake close to the evaporator about $20 on ebay or $90 from nissan. Its more likely the flap doors are stuck or a lever come off drive motor so you cant adjust air flow.
Hi The EGR doesn't work when engine is cold at idle or full throttle . What the patch cable does is make the ecu think it is too cold for egr operation. It is a resistor in series with a PTC in the MAF unit, I measured it and its a 4.7k ohm. I think I got a slight increase in fuel economy to...
Hi yes this is egr coolant problem.Yes you have to bleed as per the manuel but they don't say to bleed the egr pump which is located bottom left near radiator.Pull the smaller hoses off the overflow tank and pour coolant down I think one comes from the egr cooler and valve to so prime them all...
The mid muffler on the 550 is a 2nd catalytic converter. Haven't removed it but was thinking of it.EGR failure happens, had one replaced under warranty.There not cheap and a pig of a job to change. To stop it happening again I installed egr mod which is a patch cable that connects to the MAF...