Recent content by bakerv3

Nissan Navara Forum

Help Support Nissan Navara Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. B

    Which workshop manual?

    Did you look at the manuals on the link I posted above. They look very detailed.
  2. B

    Which workshop manual?

    OK, so I'm going to answer my own question within minutes. I did a quick Google search for workshop manuals and I instantly found this resource. D40 Series Service Manuals - #navlife - The Home of Nissan Navara The EM.pdf seems to have everything I need :cool:
  3. B

    Which workshop manual?

    Hi all, Which workshop manual should I get to guide me through changing the timing chain on my 2006 D40 2.5 diesel? I've seen a couple of YouTube videos which are very helpful, but would like the manual for torque settings etc.
  4. B

    YD25 stalls while idling

    I think I'm OK with the job, but it's the constant earache from the wife telling me I buy sh***y cars.
  5. B

    YD25 stalls while idling

    I don't have that info. I have had it a year and only used it a few times. But I am sure it's a stretched chain now though.
  6. B

    D40 cutting out at low revs.

    Hi. Latest news. I took it to a garage with a better OBDII than me. They found a P0340 code in the ECU. This is pointing to a stretched timing chain I think. However, first I'll find the crank sensor, test it and clean the electrical connections. I've asked for a quote to change both timing...
  7. B

    D40 cutting out at low revs.

    Thanks @RobR, but unfortunately it made no difference. I've run DPF and injector cleaner through to no avail. It's off to the doctors tomorrow lunchtime. I'll update afterwards.
  8. B

    D40 cutting out at low revs.

    Latest: I took the Cam angle sensor out and checked it. When I put it back it it ticked over fine, but I hadn't done the bolt up. When back in place it's still bad. I can reproduce by pulling the sensor out a bit so it runs on tickler, but it won't rev past 2k (limp home). Not sure what any of...
  9. B

    D40 cutting out at low revs.

    So, I took the scv out, 2 ohms, physically functioning on 12v, took apart, ultrasonic cleaned and looks perfect. Reset fuel pump via pedal push timings. Still the same :-(
  10. B

    D40 cutting out at low revs.

    Hi. No, but will try tomorrow. I tested the primer bulb. It leaks back a little, but squeezing it when running doesn't help. I also rinsed out the fuel filter.
  11. B

    D40 cutting out at low revs.

    Hi all. I guess this subject has been mentioned numerous times, but I think my scenario is a little different. Nissan Navara 2006 (D40 4wd) A year ago the car ran fine. The engine seemed to pulse in waves (just the sound of it), but that was all. I got some P0135 diag errors which I just kept...
Back
Top