Search results

Hi Scotty, How's all, looks like your a busy welder. Since I got your sliders but haven't fitted them due to I can't find any one to weld to chassis for us. So have you made up u type brackets for any of your D40 sliders? Been a fair pain in the rear thought it would be simple but no.

Just had my SPC UCA fitted today boys and the guys had a lots of fun (pain in the $%#@) getting them aligned but they finally got there. My RX now has positive camber and hopefully this stops the terrible wear my KM2's have had to put up with last 2 months. I also have have now about 50mm...

Thanks guys will give WA suspension a call and see what I can do about getting these swapped out. Will keep all updated once completed.

Hey thanks for the replies guys. Just did the double check and mine are the 700lbs like yours Aussie rigid buggers. I already did the spacer reduce preload trick and yeah a little was reduced Matstx. Yep got them from 4WDUSA as I could never get hold of Greg at that time. So....... what do...

Hi all, I have installed for over a year or so now a set of Radflo coilovers from 4x4 USA for my Nav D40. The issue I have that they seem rather stiff and when I ordered these I got the 600lb/ft ratio ones for the bull bar/winch but not thinking in the USA they have V8's in their Frontiers not...

Hey buddy if your keen try these guys in the USA - courtesyparts.com They have everything for the Nissan and most times a hell of a lot cheaper.

So JPMC what was the improvement in doing the cut away of the air filter box? I thought the idea of these was to slow the air and at the same time cool it thus improving engine efficiency etc etc.

Mudjimba fellas Black RX. 09

Martin, Try these guys Nissan Parts, NISMO and Nissan Accessories - Courtesyparts.com I have done some serious time wasting research on the net and these guys have good prices for spares. Not sure of shipping costs but usually if you phone direct they help you out rather than just an email...

Tomo, Arty has had these upper ball joints changed which is great idea check out forum 2915-before-after-shots-2-lift-3. Leave the UCA alone as its $$$$ and just place a small spacer at this point with a revised upper ball joint. I'm still awaiting Arty to get back to me on where he got them...