Hi Guys
Just an update on my situation. They finally offered to supply a replacement case (after they saw this post) I told them I have since purchased a case from another wrecker which is true. They have advised they will refund my money which I am very happy about as it is some sort of...
Hi I did contact tonys and they had one with twice as many kms for twice as much money. I decided to try my luck online and thought to myself a Nissan 4x4 specialist wrecker would know what hes doing. I WAS VERY WRONG.
Update since I posted this last night, I emailed niss 4x4 the hyperlink to...
Hi Guys
Just an update on my situation. They finally offered to supply a replacement case (after they saw this post) I told them I have since purchased a case from another wrecker which is true. They have advised they will refund my money which I am very happy about as it is some sort of...
Hi Tony, I tried resetting the selector again and that worked thankfully.
I took it for a test drive and now the speedo doesn't work. The case I received does not have a hole for the front revolution sensor and if I drive any faster than approx 60km/hr the engine goes into limp mode. Is there a...
Hi guys
I just replaced my transfer case that had a flogged out bearing housing with a second hand one that has done 60km. I installed it myself with no dramas until I went for a test drive and it is stuck in 4Low. I have tried driving back and forward resetting the ECU and manually engaging...
Hi guys another update, I pulled the transfer case out the other week, when i drained it there was a metallic paste on the magnetic drain plug and when i got it apart I could see that the bearings weren't worn. They had actually spun in the alloy casing which had worn that out causing the...
Hi Guys a bit of an update: I was looking at getting a secondhand transfer case. There were some on ebay for $500 but they suit a manual so no good to me. So I rang a local Perth wrecker who wanted to charge me $1320, after I finished laughing at him I managed to find one in Melbourne for $700...
Hi, I have checked the front wheel bearings by jacking it up and checking the wheel movement and rotating them. If it was the wheel bearings would they do it all the time at 100km/hr not just with the front prop shaft installed?
That steak sounds great!! do you have any left over?
Thank you very much for that. I will follow up with the transfer case bearings on Monday and see the best option with rebuild or replace.
The vibration comes in at almost exactly 100km/hr and doesn't stop the faster you go, I don't notice it any other time. I don't believe it can be the tires or brakes as the tires have been replaced balanced and aligned and it doesn't vibrate with prop shaft out. It has to be something with the...
The driveshaft still has marks on it from where he split it, he told me it was balanced and charged me accordingly. there is a slight amount of up and down movement on the output of the transfer case. Maybe 1mm? Can anyone tell me how much vertical play you have on your Navara?
Hi Tony
I have replaced the drivers side CV (entire driveshaft actually) on the advice of Nissan as they said it was worn and could be causing the vibration however this made no difference. At the time (a month ago) they said the left hand side CV was fine. I have just checked the gearbox and...