Recent content by Toffa

Sorry, haven't been on in a while. I just pulled all mine apart, wiped them down and put them back together and they haven't leaked since

It's a manual.. So if i put it in 4wd low it should disengage fairly quick?

Ok thanks guys, I'm pulling a 2 tonne boat up the ramp so I engage 4wd. I no it shouldn't be used on high traction surfaces.. Is there anyway to avoid wind up? Would you keep car in 2wd and try pull it up?

Hi guys, just want some feed back on what your d40's do when in 4wd hi and low! Mines a 2013 manual 2.5 diesel, had it in low range trying to pull the boat up the ramp! Took off and it revved to about 3000rpm but was only crawling.. Is this correct?... Then I've also had it in 4wd hi and it...

Also leaking from that hose, and leaking from under metal body

Ok, cleaned the pipe yesterday but didnt take it for drive. Drove to work today, but exceeded 2500rpm! Took the hose off after work and it had a layer of oil on it. Again the metal part near the turbo no signs of oil and plastic part bolted to motor no oil.. Cleaned it and took it for a 5minute...

Thanks stevo, il have a look at a catch can. Tony, I noticed the leaks a week ago, gave the clamps a tighten up and wiped the metal part that comes off the turbo.. Today the oil had weeped back down the 90 degree bendshaped metal part.. It had weeped down about 70mm.. Pulled that silicone hose...

No catch can fitted.. Is it bad to get oil through there? Pulled the silicone hose off with the clamps that connects from metal near turbo to the plastic bit before the intercooler pipe and put finger in both ends and they seemed clean.. Didnt feel like any oil had gone through them.. But the...

Hi guys, have a d40 navara 2013 st with only 5000km fitted egr blanking plate about a month ago 1. last few weeks I have been noticing a whirring noise coming from the car when revs are dropping when changing gears and when car sitting in driveway in neutral revving it and taking foot off...

Hi guys, have a d40 navara 2013 st fitted egr blanking plate about a month ago 1.last few weeks I have been noticing a whirring noise coming from the car when revs are dropping when changing gears and when car sitting in driveway in neutral revving it and taking foot off accelerator, can hear...

Does anyone know if a 2013 navara is the same? Cut a tee piece in on the drivers side of intercooler? (Can't see on that side of intercooler without pulling the grill off)! Also where did you tee in to get your power from for the gauges? Thanks

Thanks mate, anyone no any good installers in Melbourne?

Can someone recommend a decent boost and egt gauge that won't cost an arm and a leg? Also does anyone know anyone in eastern suburbs of Melbourne that could do an install? Thanks

Are they also the euro 5 ones?

Thanks tony Malicious - did you buy your plate off the net? Ebay? Thanks