Recent content by Sean H

Wish it was that easy. Some brands will supply the code if you have proof of ownership. Not Nissan, they want to charge $160

Is there an inexpensive way to find out my radio code for my D40? I bought an auction car, so history is lacking

They're a lot of fun. I have done miniature train wheels before. Our printer is worth close on $1 mill.to get that sort of detail

The plastic pipe on my D40 snapped off, so I designed and 3d printed a repair piece. I filed back the snapped pipe and slightly drilled the remaining orifice. Slid the HP MJF printed part into the orifice with a coating of glue.It has a reinforcing block to take the load off the pipe. Worked a...

For general information - I dismantled this D40 side mirror with non-functioning indicator. The lens had cracked, allowing water ingress. As seen here the circuit board components are toasted. Take care if ordering mirrors onine. Several variants of harness plug,depending on functions included...

Thanks Tony, Responded a couple of times but I can't see it. For the moment I think it's o.k. Connected vacuum direct to the turbo actuator and took it for a run. Spools up o.k. Reinstated the plumbing and it seems much smoother now. Low idle lumpiness has gone away and now has steady idle...

Hi I am in Brisbane. Apologies for the slow response

Hi all, I have a D40 which breaks down/misfires between 1000-1500 rpm. After that it revs smooth and strong. The car has been sitting for a while after engine swap (used). Has new timing chains, fresh fuel, new fuel and air filter. I have cracked the fuel lines to bleed any air out of the lines...

Greetings, I have a 2008 D40 and a 2013 D22. Hoping to add and gain some knowledge from other members