Recent content by s.weapon

yep that's the tyre. no rubbing even off road. still needs a wheel alignment so not quite out of the woods yet, they have a massive effect on the overall car! its not half as capable in the sand as it was.. with such a wide track I couldn't follow other tracks so was constantly ploughing loose...

it has an Xroxc bar mount on it.. except they sent me d22 wings not d40 wings! so it currently looks like this.. got no hoop on the xrox and think it will look spot on when complete.

So I destroyed my fuel economy & made the thing much slower... But I dont really care! 2 inch body lift 2 inch strut spacers 0 offset 16x8 Trimmed plastic inner wheel arch 60mm wheel arch extensions going on tommorow

yeh right, ok. it feels like ive put a short shift kit in the car as the selector is about 2/3s as high now. might have a play around with the mounting points, see if I cant shift the console backwards a bit.. I had wondered if Id missed a step and needed to move some things around beneath the...

Gday guys Installed a 50mm body lift last night, looks good v happy except now when I select reverse to get the gear in the selector contacts the plastic around the cutout in the centre console. Anyone else had his happen? It's not the end of the world but doesn't feel great when using it...

2011 kingcab... doesnt have half the stuff on it the dual cab stx's have though, so im not suprised!

????? ive got an STX, and i dont have those switch blanks!

ummm... i bent mine on the weekend trying to reverse out of a mudhole and had to cut it off just after the muffler before the axle, and ive lost torque.... are you sure you want it shorter?

got one in! but.... used the nissan rails and its sitting 50mm too high. no idea how im going to get the drivers side lower, but its not acceptable at that high, cos the sides of the base are so bolstered it a pain in the arse to get in and out!

i dont care what side the 4wd selector is on, its the switch locations i need.. so some aussie cars have the 4 blanks instead of the cubby hole? will check out the links above..

S.A / VIC border track on the weekend.. did i make it through?

going with these... $179 each from autobarn on special. done some quick reading and think i will remove the existing seats, and get 4 flat steel bars made up, drill some holes and bolt 2 along the existing rails, and then 2 from side to side and mount hte seat to those cross bars. ill let u...

ok, definatly no side airags in my seat... and looks like the seat bolts to the rails quite simply on the bottom... so going to buy some buckets tommorow and then deal with how i install them! may need some special brackets made up i expect as racing buckets would prob sit lower than 4x4 seats...

Nah Aussie truck, think it was grey?

Looks messy!