Recent content by kasdsmn

Pcd size Hello, its probably too late but the pcd size you have is correct, it is 6/139.7 dont forget the centre bore/spigot size is 110mm also, i am 99% sure you will need an offset of about +30 too, but if you can fit one to see for yourself great!! dont know about the measurements he gave...

Hey, right all is sorted!! Found a set, did some measuring and research and they will fit given the offset and should be fine just need a wise tyre choice to get decent clearance etc. They are off 2009 model prado selling Qld approx $1300 a full set. Just saving $$ for the new ute, looking at V6...

Thats a good point, i hadnt thought about that at all. I think some research into exactly which prado model they were off is in order. I dont want to jump the gun and find out later things are breaking under too much stress etc. I think they are off 09'-10' model, i know where the ute is so i...

Hey guys, saw a rodeo with late model prado wheels on it, i know the stud pattern is the basically the same so they should go on, but want to know if the offset will work over the hubs and if they will rub too badly, any advice on this would be great as i am still learning!! reackon these would...

Hi all, i have an 89 D21, been i really great ute so far havent done a lot to it other than replace bits n pieces i have broken, put a late model tray on it and bought it with front that matches that, been rather neglected the last two years but want to start doing a bit of work to it soon so i...