Has anyone replaced/ sourced the nylon bushes that seat in the fan belt tensioner pulley shockey? One seats on the bottom of the little tensioner shockey and bolts into the engine block. You cant buy parts for them from nissan or parts stores. You have to buy pretty much the whole setup.
Hi, in reading this my ute doesnt seem to have a problem but can someone clarify for me what the NPS is for (the "heat" switch located botttom right of steering column)? Im guessing you use it in cold climates to help warm the motor up quicker but also, from reading this thread it will stop the...
The last couple of weeks once my gearbox gets hot I can smell gear box oil in the cab once I change gears. I have pulled the gear lever out and noticed the nylon bushes plus the gear lever housing to be slightly worn. Has anyone else had this problem and how much did the parts cost? I have...
I have done a search but can't seem to find anything on aftermarket seat modification for a d22. Has anyone changed their front stock seats to seats from other vehicles? How hard was it to get the base to fit the new seat? Or is it simply easier to put aftermarket seats in (eg recaro etc)?
Hi,
I want to put a roof rack above the canvas canopy that will attach to the head board and rear roll bar of my steel tray. The problem I have is how to safely mount the roof rack to the tray to compensate for the issue of sheer force (stopping in a hurry and not having the weight break the...
Hi all,
I have bought a tray to go on my D22 dual cab. It came off the current model hilux dual cab and of course has different mounting points to the navara. Can anyone please help me with some measurements I need?
- The height of the tray brackets/ cross members (eg 100mm 'C' section, etc)...
Hi all,
I am changing my ute tub to a steel tray and want to put a canvas canopy on with roof bars or tradie rack for my roof top tent. I am trying to decide on the best way to install roof bars, etc on top of the canvas canopy. Does anyone have a setup like this or have seen one. Pictures or...
I was finally able to get my 3" mandrel bent exhaust done but unfortunately the bloke coundn't bend the pipe to make a new dump pipe. However, he was able to "clean" out the original cat. Personally I wanted it from the turbo back but I'm not complaining as I believe it was a good price for what...
Just wondering if it is possible to get the ECU re-programmed to improve fuel economy and power instead of putting a chip in and if its cost benefit is better than a chip?
If you know that the ECU can be re-programmed can you please tell me who would do it?
I have had to get my a/c regassed twice recently. First time, the gas slowly leaked out and the a/c techie thought it was an issue with the valves where the gas is removed and injected. The second visit he replaced the valves and o rings on the compressor where the pipe connects. He checked for...